| CES : BGW Performance Series |
BGW Power Amplifiers |
BGW Performances Series Specifications
Power Output Per Channel .1% THD @ 1kHz in Watts
Stereo Mode Bridged Mono
8 ohms 4 ohms 2 ohms 8 Ohms 4 Ohms
PS 1 110 165 330
PS 2 220 330 660
PS 3 330 500 700 1000 1400
PS 4 440 660 925 1320 1850
Intermodulation Distortion Less than 0.05% at rated output
(SMPTE method, 60Hz & 7kHz, 4:1 ratio)
Small Signal Frequency Response 8Hz - 175kHz +0, -3dB
DC Offset Voltage Less than 10 millivolts at output terminals
Hum and Noise Level Better than 100dB typical below rated
output into 8 ohms (A-wtd., 20Hz to 20kHz)
Min. Input Impedance (/ch) 10k ohms balanced
Input Sensitivity 0.775 Vrms for rated 8 ohm output: or 1.55 Vrms (PS4)
Voltage Gain PS1 33.2dB PS2 34.2dB
PS3 35.7dB PS4 37.2/31.2dB
Damping Factor Greater than 200:1 (ref. 8 ohms)
Load Impedance 4 ohms or greater (PS1 & 2)
2 ohms or greater (PS3 & 4)
Power Specify operation for either 120,
220 or 240 volts AC, 50-60 Hz
Dimensions
Height 2U 3.5 inches (8.89 cm)
Width 19 inch standard rack front panel (48.3 cm)
Depth 12.6"(PS1) 12.6"(PS2) 13.6"(PS3) 17.1"(PS4)
Weight Net/Shipping 26/31 lbs 32/37 lbs 37/40 lbs 53/58 lbs
Due to continuous product improvements, all specifications and features are subject to change without notice.
| Thanks to BGW
We would like to thank BGW for allowing us to place this information on our website. Any reproduction of information from this page must go through BGW for permission. |